In the Box
The Epson TM-m10 and TM-m30 Ethernet Printers ship with a roll of paper, wall adapter, adapter cable, and manual.
Printer Hardware Setup
Before using the printer in ShopKeep, set up its hardware by connecting it to power and to your router.
You must have Wi-Fi at your location and access to the router to be able to set up this printer. The printer must be plugged into a router via ethernet cable to connect wirelessly with the iPad.
- Locate the bottom panel with four rubber feet.
- Pull the bottom panel away from the printer to remove it.
- Remove the side panel.
- Plug the power adapter cable into the adapter port.
- (Optional) Connect a cash drawer to the printer.a. Plug the small end of the cash drawer cable into the printer’s cash drawer port.
b. Plug the larger end of the cable into the cash drawer.
- Plug an ethernet cable into the printer’s network port.
- Connect the opposite end of the ethernet cable to a numbered port on the router.
- Snap the printer’s bottom panel back into place.
- Snap the side panel back into place.
Both panels are interchangable. Attach them in whatever orientation works best for your business. - Connect the adapter cable to the wall adapter, then plug the wall adapter into a power outlet.
- Press the power button to turn on the printer.
- Lift the printer’s latch to open its cover, load the paper, and close the cover on the paper.The paper must feed from the bottom of the roll as shown below.
- Wait for the status light to turn solid blue.
